Description:
1) high-accuracy voltage detection circuit;
2) terminal of the charger using high voltage device;
3) Built-in three-stage over-current detection circuit (over-current 1, over-current 2, load short circuit);
4) MOS transistor can control the battery charge and discharge.

Note:
The BMS is used for 3.7V li-ion battery without balancing function

Q: I'm not getting a voltage reading between P- and P+
A: Connect a charger or power supply to the BMS and feed it at charging voltage for 1-3 seconds and then try again

Package Included:
1x BMS

#DIYMORE #1S #3.7V #18650 #MOS #Li-ion #Lithium #Battery #Charging #BMS #Protection #Board