✍ GY-521 MPU6050 6DOF 3-Axis Gyroscope and Accelerometer Module is a carrier board based on MPU-6050 sensor which contains an accelerometer and a gyroscope. MPU-6050 sensor contains a MEMS accelerometer and a MEMS gyro in a single chip. It is very accurate, as it contains 16-bits analog to digital conversion hardware for each channel. Therefore it captures the x, y, and z channel at the same time. The sensor uses the I2C-bus to interface with microcontrollers.

✍ The MPU-6050 always acts as a slave to the Arduino with the SDA and SCL pins connected to the I2C-bus.
But beside the normal I2C-bus, it has it's own I2C controller to be a master on a second (sub)-I2C-bus. It uses the pins AUX_DA and AUX_CL for that second (sub)-I2C-bus.

- - - - - - - - - -- - - - - - - - - - - - - - - - - - - -- - - - - - - - - - - - - - - - - - - - -

It can control, for example, a magnetometer. The values of the magnetometer can be passed on to the Arduino.

▼Specifications
Chip: MPU-6050
Power supply: 3V ~ 5VDC
Communication mode: standard IIC communication protocol
Chip built-in 16bit AD converter, 16bit data output
Gyroscopes range: +/- 250 500 1000 2000 degree/sec
Acceleration range: +/- 2g, +/- 4g, +/- 8g, +/- 16g
Immersion Gold plating PCB, machine welding process to ensure quality
Pin pitch: 2.54mm

===========================================

▼ Packing list
1 x Module
2 x Pins

▖▖▖▖▖▖▖▖▖▖▖▖▖▖▖▖▖▖▖▖▖▖▖▖▖▖▖▖▖▖
???? Anything can ws us @ +6018 2870 232 ✅