All sets come with a micro-controller and transparent box

▼ UNO Basic Kit Contains :

• Plastic Box Container x1
• UNO R3 x 1
• USB Cable & Power x1
• Solderless Breadboard (Half Size) 400 tie point x1
• Red LED 5mm x5
• Green / Blue LED 5mm x5
• Yellow LED 5mm x5
• Tactile switch x6
• Tactile switch cap x6
• Photoresistor x2
• Jumper Wire Male-Male 20cm 20 way
• Resistor 1/4W 5% (220R) x5
• Resistor 1/4W 5% (1K) x5
• Resistor 1/4W 5% (10K) x5
• Resistor 1/4W 5% (100K) x5
• 9V Battery Snap with DC Plug x1

▼ UNO Starter Kit Contains :
(Shown as photos)

• Base on Basic Kit upgraded:
• Larger plastic Box Container
• Full-size breadboard 830 tie point
• Proto-shield
• Motor: SG90 micro Servo motor , 28BYJ 5V Stepper
• IR (Infrared) Remote Control & Receiver
• Display: 16x2 LC , Dot Matrix, 7-Segment
• Sensor: LM35 Temperature
• 74HC595, Male-Male jumper wire, 10k-ohm variable resistor, 40-pin Male Header

▼ UNO Premium Kit Contains :
(Shown as photos)

• Base on Starter Kit upgraded:
• 1 Channel Relay Module
• Sound Sensor Module
• DHT11 Humidity & Temperature Sensor Module
• Keypad Tactile 4x4 Module
• Water Level Sensor Module
• Joystick Module
• RTC DS1302 Module
• 3 Color RGB LED Module
• Deducted a Proto-Shield from Starter Kit